<<< CLICK HERE FOR PREVIOUS PAGE

GENERAL INFORMATION

• Hi-Heat Black is a superior, high temperature coating.
• It is a great coating for engine parts or exhaust systems on cars, trucks, motorcycles, small engines, etc. where high temperature is a concem.
• It features fast coverage and cures to a beautiful semi-gloss jet black finish that will endure 1400°F with no flaking or discoloration.
• Hi-Heat Black comes ready to spray and no reduction is required.
• Parts are dry enough to handle in one hour.
• No baking is required.

1. PREPARATION

• For new steel surfaces make sure metal is bare and clean with no traces of water, oil, wax, or surface rust.
• Wiping parts with a quality, mid temperature lacquer thinner (such as House of Kolor 202 Lacquer Thinner) works well as a final wash.
• Allow to dry, then start application.

• For previously coated or rusted surfaces, sand or bead blasting is the only method of preparation recommended.
• After blasting, prepare surface the same as described above for new steel surfaces.

NOTE: Sand or bead blasting is the ideal surface preparation for all surfaces including new steel surfaces.

2. APPLYING HI-HEAT BLACK (HH-04)

• Hi-Heat Black is ready to spray as packaged.
• Do not add any extra reducer.
• Apply one medium wet coat.
• Allow 10-20 minutes dry time or until paint has flashed, then apply one more medium wet coat.
• Apply just enough paint to achieve coverage, but never more than two medium coats of HH-04.

WARNING: Proper film thickness is critical for good heat resistance properties. Dry film thickness should not exceed .6 mlIs. Excessive film thickness will cause coating failure such as blistering and flaking. More is not better.

• Parts are ready to handle in one hour.
• Allow parts to cure for 24 hours after last coat is applied to ensure that solvent is no longer present in the coating.
• Final cure will be accomplished by the inherent heat of operation. This will cause the parts to emit smoke and odor upon first use. This is a chemical reaction that finally cures the paint.
• After this, the parts will be a beautiful semi-gloss black finish.

3. CLEAN UP

Clean equipment thoroughly with thinner.