RA3000 Air Regulator & Water Trap

Includes connection fittings for use with the D3000 Compressor (above).

PAS RA3000 - Air Regulator & Water Trap

R-75AR Filter Regulator

The R-75AR is an in-line low pressure regulator with a 100 P.S.I. gauge and moisture drain. This regulator gives user control of operating pressure as well as assisting in furnishing clean, dry and regulated air. Regulators must only be used as instructions and warnings specify. Five (5) micron filtration, 15 SCFM @ 50 P.S.I. Includes: HF-33 1/4"M X 1/4"M Coupler.

PAS R-75AR - Filter Regulator

Regulator / Water Trap / Gauge Unit ABD TFR-2000

This is the same great true diaphragm Regulator/Water Trap combo that comes with many of the new compressors. The TFR-2000 unit will fit 95+% of all airbrush compressors and provide you with clean, dry, regulated air for consistent airbrush control. The TFR-2000 comes with 1/8"output fittings so any standard airbrush hose will connect right up to the new unit. Every airbrush compressor deserves a quality regulator / water trap and this is a Best Buy for sure!

4, 6, and 8-Outlet Manifolds

PAS HFM-4-1/4 - 4 Outlet manifold with 1/4 Inch connections (shown)
PAS HFM-6-1/4 - 6 Outlet manifold with 1/4 Inch connections
PAS HFM-8-1/4 - 8 Outlet manifold with 1/4 Inch connections

Valves

PAS D535 - Bleeder Valve for Paasche D500 & D500S

PAS HF-1/4" - 1/4" - Valve Assembly. Used to control air source

PAS HF-1/4"-90 - 1/4" - 90 Elbow. This elbow (1/4"M x 1/4"F is used to change the direction of the air outlet.

PAS 3A - Needle Valve (controls air volume to airbrush)

PAS 3B - Pressure Tank Valve. Used with the Paasche No. 2 and No. 17 Air Propellant cans to control the air volume to the airbrush.